I can see my new things in webcore

[Dycocha]

1) Give a description of the problem
(PUT YOUR INFO HERE)

2) What is the expected behavior?
(PUT YOUR INFO HERE)

3) What is happening/not happening?
(PUT YOUR INFO HERE)

4) Post a Green Snapshot of the piston
(UPLOAD YOUR IMAGE HERE)

5) Attach any logs (From ST IDE and by turning logging level to Full)
(PASTE YOUR LOGS HERE BETWEEN THE MARKS THEN HIGHLIGHT ALL OF THE LOGS SND CLICK ON THE </> ICON TO FORMAT THEM)

REMOVE BELOW AFTER READING
If a solution is found for your question then please mark the post as the solution.

[michicago]

Go into your SmartThings app, choose Automation at the bottom, then the SmartApps tab, and choose webCoRE.

Once in there, click Settings, then “Available devices and contacts”, then “Available devices” and add all your new devices in there. Most of them can be found under the “which actuators” or “which sensors” groupings.

Once that’s done, you might need to close and re-open webCoRE on your phone or browser, whichever you’re using, to force a refresh of the devices available.

[Dycocha]

Thank You Michigaco,

i was forget dat i have to do this i hope it wil works

[Bry]

Go into your SmartThings app, choose Automation at the bottom, then the SmartApps tab, and choose webCoRE.

Once in there, click Settings, then “Available devices and contacts”, then “Available devices” and add all your new devices in there. Most of them can be found under the “which actuators” or “which sensors” groupings.

Once that’s done, you might need to close and re-open webCoRE on your phone or browser, whichever you’re using, to force a refresh of the devices available.

You must be clairvoyant!

[michicago]

LOL, a brief moment of clarity, but it has passed now.