1) Give a description of the problem
Cannot break out of an IF condition when status changes
2) What is the expected behavior?
Piston gets triggered on open/close contact change. Works OK. But When another open/close contact changes to “closed” I need to break out of the IF condition.
3) What is happening/not happening?
Cannot stop IF code execution if the status changes
4) Post a Green Snapshot of the piston
Edit by @eibyer: please post the green snapshot of the piston, not the link to execute it
5) Attach any logs (From ST IDE and by turning logging level to Full)
(PASTE YOUR LOGS HERE BETWEEN THE MARKS)
REMOVE BELOW AFTER READING
If a solution is found for your question then please mark the post as the solution.