Classic Smart home monitor broken. getLocationMode() broken can’t open pistons



A few days ago my classic Smartthings app had issues with classic smart home monitor. It would not show the three buttons to arm or disarm that system. I contacted Smartthings support and basically told me to delete the old smart app.

Fine then. I’ll just build something with webcore then! Or so I thought.

The dashboard normally shows three piston states but instead it shows the above.

I can not edit any of my existing pistons since they were all dependent on classic SHM.

Anyone else experiencing this?


I’m not experiencing the problems you see, not least because I delete SHM a while back. However I would note that {{getLocationMode()}} suggests there is more to the story, as that’s the Location mode, not the SHM mode.