Help with virtual contact

#1

1) Give a description of the problem
very simple. I just want to “OR” together two physical contact sensors to update a virtual sensor

2) What is the expected behavior?

3) What is happening/not happening?
when i try to add a task it does not give me any options for anything but “location”. I believe i just want to say “close” in the do statement

4) Post a Green Snapshot of the pistonimage

piston
piston.png1178×554 45.2 KB

5) Attach any logs (From ST IDE and by turning logging level to Full)

REMOVE BELOW AFTER READING

#2

What device type did you assign to your virtual sensor?

#3

contact capabilities.

#4

Change it to —> simulated contact sensor

#5

still only gives non device commands. do i have to do something to make webcore aware of the change of type

#6

Save the piston, then click edit again

#7

actually had to delete and recreate the device. webcore would not pickup on type change