I need a piston to have Lutron Pico remote control Sonos speakers


I’m new to this a can’t figure out to make a Lutron Pico 5 button remote control a Sonos speaker. I’m trying to control basic functions like Mute, Unmute, and Volume up/down if possible.
In settings I’ve added the remote in every category that it was available. The remote shows up under physical devices.
Under add a new condition - What to compare
I select physical device - Pico remote, but then my choices are pushed button, released button, ^$status, and ^numberOfButtons

Not sure where to go from there


I’m not sure how the pico behaves in the ST environment but you can try and start by opening live logging and pressing buttons on the pico and observe what is logged.