Reset piston while running

#1

1) Give a description of the problem
Senior moment…So I would like to do two things. Set up the piston to reset if something changes in the piston and would like for the piston to continue if something in the piston changes. I know I have it set up but it has been so long since I changed the default I can’t remember where and what to set it to based on the circumstances.

2) What is the expected behavior?
(PUT YOUR INFO HERE)

3) What is happening/not happening?
(PUT YOUR INFO HERE)

4) Post a Green Snapshot of the pistonimage
(UPLOAD YOUR IMAGE HERE)

5) Attach any logs (From ST IDE and by turning logging level to Full)
(PASTE YOUR LOGS HERE BETWEEN THE MARKS)

REMOVE BELOW AFTER READING
If a solution is found for your question then please mark the post as the solution.

#2

If you’re talking about the task cancellation policy, it can be found by clicking on the statement you want to change its policy, clicking the gear cog, and then Task Cancellation Policy should be the 2nd drop-down menu available.