Webcore and Hubitat sync

#1

1) Give a description of the problem
I just added a few new devices to Hubitat and added them to WebCore. I replaced some older devices with these on about ten different pistons, and they seemed to be running, but I will see tonight. However, when I look at the old devices, they show that they are still in the pistons I changed, and when I look at the new devices, they show no piston association. I tried to pause the app and I even tried to duplicate it the new piston did not appear in the new device. Something is hosed between webcore and Hubitat

2) What is the expected behaviour?
(PUT YOUR INFO HERE)

3) What is happening/not happening?
(PUT YOUR INFO HERE)

4) Post a Green Snapshot of the pistonimage
(UPLOAD YOUR IMAGE HERE)

5) Attach logs after turning logging level to Full
(PASTE YOUR LOGS HERE THEN HIGHLIGHT ALL OF THE LOGS AND CLICK ON THE </> ICON TO FORMAT THEM CORRECTLY)

REMOVE BELOW AFTER READING
If a solution is found for your question then please mark the post as the solution.

#2

Tried to flush the cache in webcore app in HE?

#3

That did not work. I tried just about everything. I am wondering if I was to uninstall WebCore would I lose anything. It is the weirdest thing. SO I created a new piston, and in the condition, I put in the new bulbs that I created to replace my plugs, Saved it went back to the device, and it was there. I then put it in the action, and it disappears out of the device piston list. My next step is to delete the devices and put them back in. The funny thing is, even though they are not in the device piston list, they are running just fine.