What devices and variables are being used in your Instance

#1

1) Give a description of the problem
Is there a way to see all the devices and variables that are really being used in your instance because although there should not be I have had to delete devices in my settings in order to add more.

2) What is the expected behavior?
(PUT YOUR INFO HERE)

3) What is happening/not happening?
(PUT YOUR INFO HERE)

4) Post a Green Snapshot of the pistonimage
(UPLOAD YOUR IMAGE HERE)

5) Attach any logs (From ST IDE and by turning logging level to Full)
(PASTE YOUR LOGS HERE BETWEEN THE MARKS)

REMOVE BELOW AFTER READING
If a solution is found for your question then please mark the post as the solution.

#2

There is no way to list devices being used across the instance I’m afraid.

When you say you had to remove devices to add more… that certainly shouldn’t happen unless you’re on an antique version that doesn’t have the storage app??

Can you elaborate on what happened, what told you to remove devices etc.?

#3

Trust me I have A LOT of devices. In the setup you can bring in different devices based on what you are going to use them for. Well I have a lot of temp sensors and a few times I added some new ones and tried to bring them in and I selected them, went to use them in the instance, and they were not there. Went back to add them again and same thing. I actually had to remove like all the battery devices in the setup to give me more room to add more. Now could it be something else…yep… but this has happen to me more than once.

#4

You have to refresh the browser after adding new devices, otherwise they don’t show up…

#5

Yea did all that and still had the same issue. Maybe it is just me and I will just work around it if it comes up again.