1) Give a description of the problem
Zwave fibaro switch is showing off but the light remains on and the power consumed is greater than 0w.
So do I just have to cycle the switch (Turn On, wait 2 secs, Turn Off) when this is detected?
2) What is the expected behavior?
The light is off when the switch is showing off but the physical light is on
3) What is happening/not happening?
It seems the switch is getting command to Turn Off and is according to STT but the light remains on and consuming power.
4) Post a Green Snapshot of the piston
(UPLOAD YOUR IMAGE HERE)
5) Attach any logs (From ST IDE and by turning logging level to Full)
(PASTE YOUR LOGS HERE BETWEEN THE MARKS THEN HIGHLIGHT ALL OF THE LOGS SND CLICK ON THE </> ICON TO FORMAT THEM)
REMOVE BELOW AFTER READING
If a solution is found for your question then please mark the post as the solution.