Not really a Piston problem but... Motion sensor not showing

[myk3]

1) Give a description of the problem
Motion sensor shows in ST devices, but not in WebCoRE

2) What is the expected behavior?
For the motion sensor to show up, so I can use it in a piston

3) What is happening/not happening?
Motion sensor not showing up in WebCoRE (laundry room motion)

**4) Post a Green Snapshot of the piston!

[michicago]

This should fix ya:

I can see my new things in webcore

Go into your SmartThings app, choose Automation at the bottom, then the SmartApps tab, and choose webCoRE. Once in there, click Settings, then “Available devices and contacts”, then “Available devices” and add all your new devices in there. Most of them can be found under the “which actuators” or “which sensors” groupings. Once that’s done, you might need to close and re-open webCoRE on your phone or browser, whichever you’re using, to force a refresh of the devices available.

[myk3]

Well I feel like an idiot… side question… I added 3 motion sensors and only one didn’t automatically show up in WebCoRE is that normal?

[Bry]

If you are writing a piston when you add the device, you may need to exit to the webCore control panel and then go back and edit the piston before you’ll see it.